ONE AND TWO FAMILY DWELLING
PLAN SUBMITTAL REQUIREMENTS
Submit a permit application with all applicable items completed, including inserts, when you construct a new building, construct an addition, or alter existing space.
The permit application must be signed by the property owner or his designated agent and must have a current street address.
Submit proof of workers compensation insurance, unemployment insurance and if applicable, electricians general liability insurance or
Submit affidavit of exemption, if not required by law or
If permit is obtained by owner then submit an affidavit that all contractors, subcontractors employed under said permit will be covered.
Submit site plan drawn to scale showing the following:
Lot boundaries;
Structure locations (both proposed and existing);
Proposed building setback distances.
Submit 2 sets of plans drawn to scale, minimum 1/8 inch, and including the following:
Foundation plan, exterior and interior, showing footing size, pier size and spacing, girder beam size, floor joist specie, size and orientation. If engineered floor system is used then provide a plan from the designer.
Foundation wall detail or basement wall detail. Details shall include size, location and spacing of reinforcement and anchor bolts. Basement wall detail shall include wall height to top of finished floor and height of unbalanced fill at deepest point.
Floor plan indicating the following: room use, ceiling height, window and door sizes and their location, exhaust vent locations, smoke detector location, location of hvac equipment and water heaters, braced wall panel locations including bracing method, support and anchoring.
Roof framing plan showing roof lines, specie, size and orientation of rafters and ceiling joists, any beams or purlins necessary for rafter or ceiling support, any bracing required for support of hip and valley rafters. If trusses are used provide truss spec sheet.
Wall section detail that shows footing, foundation, floor system, wall framing, wall height, exterior sheathing and finish, ceiling/roof framing, roof decking and covering. Indicate if wood structural sheathing is continuous. Indicate the R value of the roof/ceiling, the framed walls and the floor over a crawl space.
Step and stair details.
Portions of buildings not conforming to the KRC or of irregular construction shall be designed according to accepted engineering practice.
NOTE: Detached residential garages shall submit only a site plan that shows the size of building and location on the lot with distances from lot lines and other buildings.
Submit a copy of the electrical release numbers from the health dept. for both temporary and permanent power.
After plans have been reviewed and corrections noted a permit will be issued as per fee schedule or will be denied.